|
|
|
| |
Laser Carbonless Paper
Convert from Single Sheets into Glued Sets |
|
|
|
|
With the exception of the top sheet, all other
parts of the set must have a toner-free margin
at the gluing edge of at least 1/32". This will
ensure problem free gluing. Collated sets
should be carefully
jogged to
produce a perfectly smooth gluing edge.
This will allow for even glue penetration of the
laser carbonless glue into the coatings. The forms
should be handled carefully to avoid damage from
excess pressure.
We recommend
to carry out a trial on a small stack of forms
to establish both the recommended amount of
adhesive application and correct drying time.
|
|
|
|
|
|
 |
|
The stack height for gluing should not exceed 11
3/4" and a waterproof board should be placed on
top. A weight of 2.2 - 4.4 lbs placed on
top is also recommended.
Shake the
glue before use. A
small amount of adhesive should be poured into a
small non-metalic container. The glue
should be applied generously with a 2" soft
bristled brush using horizontal strokes until
the gluing edge is uniformly glossy.
|
|
|
|
|
|
 |
|
We do not recommend the use of heaters to
accelerate drying. Separation of the sets
should be carried out by lateral sliding of the
sets. This separation should take place
after 30 minutes.
Complete
drying/bonding is complete after 2 - 3 hours after
gluing. The forms are now ready for use. |
|
|
|
|
|
|
| |
|
|
|
To order samples or
for more information
click
here.
Or call Relyco
1-800-777-7359 or email us at
info@relyco.com |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
 |
Corporate Headquarters
100 Main Street, Ste 222 - Dover, NH 03820
Tel: (800) 777-7359 - (603) 742-0999 - Fax: (603) 742-9993 |
|
|
|
|
|
|
|
|
| |
Home
-
Company -
Products -
Services -
Solutions -
Partner Program -
Contact Us
|
|
|
|
|
|
|
|
|
|
|
